Use and Care Manual

13
ASSEMBLY
================================================================================================
1018348-A
Assembly Step 13-A
Adding the Handle
1. Temporarily remove the drop hitch pin (38)
from Assembly Step 8 and rotate the push
arm assembly away from the spring.
2. Run a hex head bolt, 3/8” x 3 3/4” full thread
(43) through the rst hole of the push arm
assembly & add:
- x 1 Hex Nut (44) – 3/8” External-teeth
facing the lower handle tube.
3. Align the lower handle tube (14) and
continue to run the hex head bolt (43)
through the handle.
9/16” Wrench & Socket
Assembly Step 13-B
Adding the Handle
4. Rotate the push arm assembly back to center and
replace the drop hitch pin (38) from Assembly Step 8.
5. After the bolt (43) extends through the tube, add:
- x 1 Hex Nut (44) – 3/8”
External-teeth facing the lower handle tube.
6. Continue running the bolt (43) through the push arm
assembly. Secure in place using:
- x 1 Lock Nut (36) – 3/8”
7. Use the two Hex Nuts (44) to center and secure
in place the lower handle tube (14) within the opening
of the push arm assembly. (See detail to the right).
push arm
assembly
lower
handle
tube
43
36
14
44
44
9/16” Wrench & Socket
43
43
43