Use and Care Manual

10
**Exterior circumference of washers can vary.
These dimensions are a measurement of the
internal diameter of the washer.
1/2”
**
3/8”
**
5/16”
**
1/4”
**
0”
2”
4”
1”
3”
5”
ASSEMBLY
================================================================================================
1018348-A
Push Arm Assembly
2. Attach pivot weldment (8) to the push
arm assembly using:
- x 1 Hex Head Bolt (32) – 1/2” x 2”
- x 1 Washer, Flat (35) – 1/2”
- x 1 Washer, Thick (19)
- x 1 Lock Nut, Hex (37) – 1/2”
NOTE: Do not over tighten,
the two brackets should be able
to move freely of one each other,
but not so loose that there is play
in the joint.
Push Arm Assembly
3. Drop hitch pin (38) into the
center hole of the push arm
assembly and secure with a
hairpin (45).
Assembly Step 8
8
37
32
45
38
35
20
push arm
assembly
push arm
assembly
pivot
weldment
3/4” Wrench & Socket
Assembly Step 7