Instructions / Assembly

13
**Exterior circumference of washers can vary.
These dimensions are a measurement of the
internal diameter of the washer.
0”
2”
4”
1”
3”
5”
1/2”
**
3/8”
**
5/16”
**
1/4”
**
ASSEMBLY
================================================================================================
1018348-C
Joining the Push Arm to the Blade
5. Mount trip spring by treading 3/8” x 2 1/2” full
threaded bolt (46) and 3/8” washer (34) so that the
head of the bolt is captured
inside of spring (15).
6. Hook the opposite
end of the spring
(15) through the
pivot weldment (8).
7. Insert the bolt through
the trip bracket (18) that
was installed on Assembly
Step 12.
Tread and tighten the 3/8”
toothed nut (44) until the
spring is touching the
bracket.
Assembly Step 13
18
46
15
44
34
8
9/16” Wrench & Socket
8. Tighten the nut and bolt that were added
on Assembly Step 12.
Joining the Push Arm to the Blade
4. Attach spring trip bracket (18) using:
- x 1 Hex Head Bolt (29) – 3/8” x 1 1/4”
- x 1 Washer, Flat (34) – 3/8”
- x 1 Nylon Lock Nut (41) – 3/8”
DO NOT tighten completely (yet).
18
41
34
29
9/16” Wrench & Socket
Assembly Step 12