Instructions / Assembly

10
**Exterior circumference of washers can vary.
These dimensions are a measurement of the
internal diameter of the washer.
1/2”
**
3/8”
**
5/16”
**
1/4”
**
0”
2”
4”
1”
3”
5”
ASSEMBLY
================================================================================================
1018348-C
Push Arm Assembly
2. Attach pivot weldment (8) to the push
arm assembly using:
- x 1 Hex Head Bolt (32) – 1/2” x 2”
- x 1 Washer, Flat (35) – 1/2”
- x 1 Washer, Thick (19)
- x 1 Lock Nut, Hex* (37) – 1/2”
NOTE: Do not over tighten,
the two brackets should be able
to move freely of one each other,
but not so loose that there is play
in the joint.
8
37
32
35
19
push arm
assembly
Adding the Handle
1. Rotate the pivot weldment (8)
2. Start to run hex head bolt,
3/8” x 3 3/4” full thread (43)
through the rst hole of the push
arm assembly & add:
- x 1 Hex Nut (44) – 3/8”
External-teeth need to be facing
away from the head of the bolt.
Assembly Step 8-A
43
44
8
rotate
the pivot
weldment
rotate
the pivot
weldment
pivot
weldment
3/4” Wrench & Socket
Assembly Step 7
9/16” Wrench & Socket
*Not the Nylon Lock Nut (42).