User Manual
6 7
ASSEMBLY INSTRUCTIONS ASSEMBLY INSTRUCTIONS
1. Determine mounting method to use.
A - Downrod Mount (normal or angled ceiling)
B - Closemount (normal ceiling only)
Important: If using the angle mount, check to
make sure the ceiling angle is not steeper than 20°.
4. Install the mounting bracket (A) to the outlet box
(not included) using the two screws provided
with the outlet box. Securely tighten the two
screws.
2. Removeanddiscardtheverubberinsertsandve
mounting screws from the underside of the motor
housing assembly (E).
2. Insert downrod assembly (D) through canopy
(B) and canopy cover (C). Thread wires from the
motor housing assembly (E) up through downrod
assembly (D).
Outlet box
A
4
3. Remove the mounting bracket (A) from the
canopy (B) by loosening the four preassembled
screws on the top of the canopy (B). Remove
the two non-slotted screws and save.
1
A
B
A
B
Loosen but
do not remove
Remove
and save
3
If using the angle mount, make sure open end of
mounting bracket (A) is installed facing the ceiling.
Follow mounting instructions for Downrod Style
Fan Mounting on page 7 or Closemount Style
Fan Mounting on page 8, depending on mounting
method (A or B) chosen in step 1 on page 6.
DOWNROD STYLE FAN MOUNTING
1. Remove pin and clip from downrod assembly
(D) and save.
E
Rubber
insert
and screw
2
D
Pin
Clip
1
C
B
D
2
Page 6 Page 7