Owner Manual

INSTALLATION
INSTRUCTIONS FOR USE
Thank you for choosing and using our products.
Aer opening the product package, please check the accessories
according to the following table and the following figure(s).
1. Remove old shower head from the shower arm.
2. Clean the threads on the shower arm. There can be some
residual thread sealing tape or mineral deposits on the arm,
which can be cleaned off. Using mild soap and water and/or an
old tooth brush.
3. Wrap the teflon tape ghtly around the shower pipe evenly for
4 to 5 wraps clockwise (please refer fig.1).
4. Twist the diverter on the shower arm , then twist the rain
shower head on the diverter male thread.
Connect the shower hose with the other male thread with the
diverter .
Please note the rubber washers must be used here at the
connecons. (please refer fig.2).
5. Set the handheld shower holder on the posion you want,
three opons available as below.
6. Turn on the water and check for leaks. If leaks occur, shut off
the water and check the rubber washers at the connecon
parts and ghten further.
For glass or smooth tiles
clean the surface, push
the suction cup on and
rotate the level .
A.
C.
B.
For texture tiles, use the
single side adhesive disc to
help create a smooth surface
for the suction cup to work.
Glue the wall bracket on the tile with 3M tape, lock the holder
on it by rotating the level.
Installation guide
Serial
number
name
quanty
1 Rain shower head 1
2 Flow restrictor 2
3 Rubber washer with Filter 1
4 Diverter 1
5 Rubber Washer 1
6 Rubber Washer 2
7 Hand shower 1
8
Handheld shower
holder
1
9 Shower hose 1
10 Teflon tape 1
Clean
1.
!
3.
gap upside
2.
72H later
wall bracket
4.
handle
9
6
6
4
5
3
8
7
1
Shower arm
fig.1
fig.2
3.
2.
1.
!
4.
3.
2.
1.
!
Tearing film
TROUBLESHOOTING
Dilemma 1.
No water flow from installed shower head.
Quick fix:Confirm previous shower washer is not in the
J-pipe
Further:Confirm that there is only one washer and that
it isn’t in the pivot ball.
Dilemma 2.
Low water pressure or missing spray paerns.
Quick fix:Clean shower head in vinegar/water
soluon(See care&cleaning secon)
Further:Clean the water filter.
Dilemma 3.
Leaking at large nut connecon.
Quick fix:Confirm only one washer is seated on top of the
water filter.
Further:Grate bar of soap across the j-pipe threads to act
as a sealant.
Alternave:Confirm water filter is firmly seated in nut.
Dilemma 4.Shower head is too ght to change angle.
Quick fix:Reinstall shower head to provide addional l
everage to change angle of spray.
10
5
4
3
2
1
7
8
6
6
9
2