Owner Manual

6 | P a g e
12) Mark the mounting position to the lower mount (10) with a pencil.
pencil
13) Drill 30mm (1 ¼”) deep hole with a diameter of 6mm (1/4”) hole in the center of the
mark with the drill. Then insert the wall anchor (9) into the hole and use a Phillips
screwdriver to apply the lower mount screw (11). Lock the lower mount (10).
14) Insert the Top Tee (4) and the Diverter Body (12) of the shower rod into the water inlet
fitting (2) and the lower mount (10). Then use the hexagonal wrench (6) to tighten the
hexagon socket screw set (19).
2
4
10
12
6
19
6
19