Owner Manual

4 | P a g e

[IMPORTANT: If shower arm is located above tile/fiberglass wall surface, you must add

distance from sheetrock to face of tile/fiberglass shower wall to the above

measurement.]

[NOTE: If the length of the 3" brass connector provided does not match the above

formula, please go to the hardware store to purchase a suitable brass connector.]

7) Apply PTFE Thread Sealant Tape (5) on the ends of the nipple (1).

8) Screw the nipple (1) and the water inlet fitting (2) by hand.

[IMPORTANT: The nipple end with a shorter thread is connected to the wall outlet and

the other end is connected to the inlet fitting (2).]

Short thread

NPT

[NOTE: Please replace the two “O” Rings of the inlet fitting (2) with the attached spare

“O” Rings when inlet fitting has leaking problem after installing]

oring

9) Use an adjustable wrench or a 3/8” (10mm) hexagonal wrench to tighten the fitting (1)

and the inlet fitting (2) to the built-in pipe outlet at the same time.