Owner Manual
3 | P a g e
4) The Decorative Cover (3) is fitted into the Top Tee (4) and the Diverter Body (12).
[HINT: Apply soapy water to the ORING position of the decorative cover to facilitate
assembly]
4
12
3
3
5) Install the Rubber Washer (13) into the Swivel Joint (14) and tighten it with the lower
end of the Diverter Body (12).
[NOTE: Do not screw too tightly, adjust the position and then tighten.]
12
13
14
6) Determine the required length of the NPT Nipple (1):
a. Place mark on existing shower arm at wall surface. Unscrew shower arm from
elbow in wall.
b. Measure distance from mark on shower arm to end of the shower arm threads.
Add ½” to this measurement, and then round to the nearest ½”.
i. Example 1: If measurement = 2 ¼”, add ½” = 2 ¾”; rounded = 3” NPT
nipple – this is the length needed.
ii. Example 2: If measurement = 2 5/8”, add ½” = 3 1/8”; rounded = 3” NPT
nipple – this is the length needed.