Specifications

6
Introduction
CONTROLLER FEATURES
The generator controller was specifically
designed for standby applications. It is
equipped with monitoring and shutdown capa-
bilities to ensure proper function. Any tamper-
ing or adjustments to the controller can cause
serious injury and/or death.
♦Hour meter
♦Switches
• AUTO/OFF-RESET/MANUAL
♦Automatic Fault Shutdowns
• Overcrank
• Overspeed
• Underspeed
• Low Oil Pressure
♦ 7-amp Controller Fuse
HOUR METER
The hour meter serves two purposes: it tallies
the hours of operation, and it serves as a
bench mark for your maintenance schedule.
SWITCHES
The AUTO/OFF-RESET/MANUAL switch is a
three-position toggle switch.
AUTOMATIC FAULT SHUTDOWNS
If the generator set fails to start after 5 at-
tempts, the overcrank shutdown will be
activated. The engine is also equipped with
an oil pressure switch that will activate the low
oil pressure shutdown if the oil pressure
drops, and a high temperature switch that will
activate shutdown. These errors are signified
by a solid RED light on the control panel.
7-AMP CONTROLLER FUSE
A 7-amp fuse protects the generator controller
from damaging electrical surges. In the event
that the generator shuts down unexpectedly or
without apparent cause, check the controller
fuse first.
CIRCUIT PROTECTION
A line circuit breaker has been sized for gen-
erator output in the event of an overload or a
short circuit. If the generator set circuit
breaker trips, reduce the load, and switch the
breaker back to the ON position. The genera-
tor set will continue to run even if the circuit
breaker is in the OFF position, but there will be
no output voltage.