user manual

Compare this 60 kW control panel illustration with your generator to familiarize yourself with the location of these important controls:

System Control Panel

A - Circuit Breaker — Protects the system from shorts

and other over-current conditions. Must be ON to

supply power to the automatic transfer switch.

B - Menu/Programming Navigation Buttons — See

Menu section for details

C - USB Port — Authorized Dealer Service Use Only

D - Generator Operation Control Buttons —

•“AUTO” Normal operating position. Press and hold

button to put unit into Automatic mode. If an utility

power outage is sensed, the system will start the

generator. When utility power is restored, auto lets the

engine stabilize internal temperatures, shuts o the

generator, and waits for the next utility outage.

•“OFF” Turns o running generator, prevents unit from

starting, and resets any detected faults.

OFF must be pressed and held for more than 5

seconds in order to reset service codes.

•“MANUAL” Used to manually start the generator.

“AUTO” LED — LED will light when unit is placed into

Auto mode. LED will blink if exercise cycle is not set or

set to OFF.

E – 15 Amp Fuse — Protects the home generator DC

control circuits. If the fuse has ‘blown’ (melted open)

or was removed, the engine cannot crank or start.

Replace the fuse using only an identical ATO 15A

fuse. One spare fuse is supplied with the unit.

F - Digital Display — Displays generator mode, menu

options, service codes, and service engine indicators

NOT

for

REPRODUCTION