user manual

31
2. Disassemble panel cover to locate and check the wire
connections (A, Figure 66).
3. Locate battery winding connector (B, Figure 67) and
mesure resistance across the terminals (C).
Figure 66
A
A
• If resistance is 0.3 - 0.7 Ω the winding is good.
• If resistance is not to specification, check wire connections,
or repair/repace wires, then retest.
• If resistance is still not to specification, replace battery
winding.
Figure 67
C
B
• Repair and/or replace any loose wire connections and
retest.
• If DC ouput is still not measured, proceed to Step 3.
Not
for
Reproduction