user manual

22 BRIGGSandSTRATTON.COM
11. Ensure the inlet needle and spring (A) are assembled
correctly, with the spring located below the float bosses
(Figure 35).
12. Using a carburetor nozzle screwdriver, remove the main
jet and emulsion tube (Figure 36). Clean as needed.
13. Using carburetor cleaner, thoroughly clean the following
components, then follow with compressed air to dry:
• Passages in the main jet
• Inside and outside of the fuel bowl
• Float
If any passages remain plugged after cleaning, replace the
entire carburetor assembly.
14. Inspect openings in the carburetor body for blockage.
Inspect throttle and choke shafts for wear or damage. If
found, replace the entire carburetor assembly.
15. Inspect all valves, openings, and o-rings for damage or
wear. If damage is found, replace the carburetor.
16. Assemble carburetor using steps 8 through 12 in reverse
order.
Figure 36
Figure 35
A
Not
for
Reproduction