user manual

13
Service Spark Plug
1. Loosen the four handle screws and remove the handle
(Figure 8).
Figure 8
2. Remove the top maintenance cover.
3. Clean area around spark plug and remove spark plug
boot (Figure 9).
Figure 9
4. Remove spark plug and inspect for pitting, corosion,
cracks, or other signs of damage.
5. Check electrode gap with wire feeler gauge (A, Figure 10) and
reset the spark plug gap to recommended gap if necessary.
Figure 10
6. Replace spark plug if electrodes are pitted, burned, or
porcelain is cracked. Use the recommended replacement
plug.
7. Install spark plug and torque to 180 in. lbs. (20 Nm).
Reinstall spark plug boot.
8. Reinstall top maintenance cover.
9. Reinstall handle and tighten the four handle screws.
Not
for
Reproduction