Specifications

Fig. 42



Replace either shaft if worn.

Replace the carburetor if the body is worn or if either

shaft clearance exceeds 0.010” (0.25 mm) when a

new shaft is used.

Disassemble

1. Remove anti-afterfire solenoid (2) or bowl screw

(1), washer and bowl (3), Fig. 43. Remove bowl

gasket (4).

Fig. 43









2. Remove fixed main jet (7) using Screwdriver

#19061, Fig. 44.

3. Remove float (5) and inlet needle (6).

NOTE: Float hinge pin (8) is swaged on one end.

Drive hinge pin out from side opposite

swage.

Fig. 44









4. Remove emulsion tube (10), Fig. 45.

NOTE: If carburetor is equipped with solenoid,

remove solenoid seat (9) first, then remove

emulsion tube.

Fig. 45





5. Use a pliers to remove the idle mixture screw

adjustment limiter cap (14) if equipped, Fig. 46.

6. Remove idle mixture screw (11) and spring (12).

7. Remove pilot jet (13).

Fig. 46

8. Remove two screws (18) and the throttle plate

(17), Fig. 47.

For Briggs & Stratton Discount Parts Call 606-678-9623 or 606-561-4983