Specifications

2. Remove air cleaner assembly.

3. Disconnect governor link at carburetor.

4. Remove governor control bracket with actuator.

5. Disconnect governor link from actuator and

remove throttle return spring.

6. Remove two screws, nuts and actuator from

control bracket.

Installation

1. Assemble actuator to governor control bracket

(3), Fig. 57. Torque screws (4) and nuts (1) to 30

in. lbs. (3 Nm).

NOTE: Hold screws (2) with a wrench when

torquing nuts. Screws must NOT turn while

torquing nuts.

2. Assemble governor link to actuator. Make sure

link snaps into hole in actuator grommet.

3. Assemble throttle return spring through slot in

governor control bracket with open end of spring

facing out and through small hole in governor

bracket.

4. Assemble governor control bracket assembly to

engine.

a. Torque four 8mm screws to 150 in. lbs.

(17 Nm).

b. Torque two 6mm screws to 70 in. lbs.

(10 Nm).

Fig. 57









5. Rotate actuator lever to position shown and

connect governor link to carburetor.

6. Connect RED and GREEN wires from control

module to actuator.

For Briggs & Stratton Discount Parts Call 606-678-9623 or 606-561-4983