Specifications

12
172
3. Assemble choke link (6) to choke lever, Fig. 33.
Fig. 33






4. Assemble carburetor (3), gasket (7), spacer (8)
and gasket (9) to intake manifold.
5. Route both solenoid wires (10) through hole in
intake manifold. Torque three screws to 65 in.
lbs. (7 Nm).
6. Install solenoid ground wire (11). Torque screw
to 65 in. lbs. (7 Nm).
7. Route long solenoid wire (12) under wire tie on
manifold, then through hole in #1 cylinder shield,
Fig. 34.
Fig. 34
11
12
8. Connect governor link (14) to throttle lever and
snap retainer over link, Fig. 35.
9. Install governor link spring in loop on retainer.
10. Assemble choke link (13) to carburetor and
choke lever. Install choke bracket (15). Torque
screws to 65 in. lbs. (7 Nm).
11. Install air cleaner elbow support. Torque screw
to 65 in. lbs. (7 Nm).
Fig. 35
13
14
15
Install Blower Housing
1. Install blower housing (8), Fig. 36.
a. Torque 6 mm screws to 65 in. lbs. (7 Nm).
b. Torque 8 mm screws to 140 in. lbs. (16 Nm).
2. Install carburetor cover (9).
3. Install rotating screen (10).
Fig. 36



Install Air Cleaner
Vertical Crankshaft
Models 290700, 303700, 350700
Current Style: (Round cartridge) Fig. 37.
1. Install new air cleaner base gasket (6).
2. Guide breather tube (5) onto nipple on breather
and install air cleaner base on carburetor mount-
ing studs.
3. Install carburetor mounting nuts (2). Do not
tighten nuts at this time.
For Briggs & Stratton Discount Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com