Specifications

12LOCKED FOR PRINTING – SELECT SECT. NEEDED >
169
Install Armatures
1. Assemble armature to engine, Fig. 20.
2. Install ground wire onto tab terminal on
armatures.
NOTE: Mounting holes in armature are slotted.
Push armature away from flywheel (arrow)
as far as possible. Tighten either screw (4)
to hold armature in place.
3. Repeat for second armature.
4. Adjust armature air gap. See Section 1.
Fig. 20


Install Control Bracket
1. Install cylinder shields (4) and valley cover (1),
Fig. 21. Torque screws to 65 in. lbs. (7 Nm).
Fig. 21





2. Connect ground wire harness to stop switch
terminal.
3. Assemble governor lever (3) to governor shaft.
DO NOT tighten nut at this time.
4. Install governor control bracket (2). Torque
screws to 140 in. lbs. (16 Nm).
Install Carburetor and Manifold
Vertical Crankshaft
Models 290700, 303700, 350700
Current style: Fig. 22
1. Assemble gaskets (1) and spacer (4) to
manifold. Make sure that locating pin (2) on
carburetor spacer fits in recess (3) in manifold.
2. Assemble carburetor onto mounting studs.
Fig. 22




Early style: Fig. 23
1. Insert carburetor mounting screws (5) through
carburetor, gasket (1), spacer (4) and gasket (1).
2. Assemble carburetor to manifold.
a. Make sure that locating pin on carburetor
spacer (2) fits in recess in manifold (3).
b. Torque screws to 65 in. lbs. (7 Nm).
Fig. 23





Models 351700, 380700
1. Assemble gaskets (2) and spacer (1) to intake
manifold.
For Briggs & Stratton Discount Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com