Specifications

7
142
2. Note location of spring tab (5) and location of
spring anchor (4) on center post of starter
housing.
3. Lower starter housing onto pulley and spring as-
sembly, Fig. 70.
Fig. 70


4. Invert assembly, rotate pulley counterclockwise
until inner spring tab engages spring anchor,
Fig. 71.
Fig. 71
Install Dogs, Dog Springs, Retainer Assembly
1. Install dogs (2) and dog springs (1) in pulley,
Fig. 72.
Fig. 72


2. Place large washer (7), brake spring (6) and
retainer (5) on pulley, Fig. 73.
3. Place small washer (4) on shoulder screw (3).
Install screw and washer in center pivot post.
4. Position tabs of retainer inside dogs. Torque
screw to 70 in. lbs. (8 Nm).
5. Install rope.
Fig. 73





Install Rewind Starter
1. Install rewind starter on blower housing and
install screws (1) finger tight, Fig. 74.
2. Pull rope to engage dogs in starter cup.
3. While holding rope, tighten screws to 60 in.
lbs. (7 Nm).
Fig. 74

For Briggs & Stratton Discount Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com