Specifications

7
141
Fig. 64





3. Lift out dogs (6) and dog springs (7).
4. Rotate pulley (8) until it disengages spring.
5. Carefully lift out pulley, Fig. 65.
Fig. 65



The starter spring and cup will normally remain as an
assembly in starter housing.
6. Remove spring and cup assembly (9) from
starter housing, Fig. 66.
Fig. 66

Inspect Spring, Starter Housing and Pulley
Inspect pulley for cracks, rough edges (1) or burrs in
pulley groove, wear on spring cup lugs (2), and wear
on center hole (3), Fig. 67. Replace pulley if
damaged or worn.
Fig. 67



Inspect starter housing for wear and sharp edges at
rope eyelet (5), center pivot post (4), and at inner
spring anchor (6), Fig. 68. Replace if worn or
damaged.
Fig. 68



Install Spring, Cup Assembly and Pulley In
Starter Housing
1. Place spring and cup assembly in pulley with
outer end of spring tab (2) between two wide
lugs in pulley (1) and spring cup projections (3)
next to the two wide lugs, Fig. 69.
Fig. 69



For Briggs & Stratton Discount Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com