Specifications

5LOCKED FOR PRINTING – SELECT SECT. NEEDED >
115
3. Loosen governor lever nut (3).
4. Remove governor lever (2) from shaft.
Fig. 5




5. Remove rust, nicks or burrs from crankshaft.
6. Remove oil fill tube and dipstick assembly.
7. Remove crankcase cover, Fig. 6.
8. Discard gasket and O-ring.
Fig. 6
Inspect Governor
1. Governor spool (3) must move freely on PTO
journal of camshaft, Fig. 7. Replace if spool
sticks or bearing is damaged.
2. Flyweights (2) must move freely on hinge pins
(1). Replace camshaft if hinge pins are loose or
governor spool does not move freely on journal.
Fig. 7



Remove Governor Shaft
1. Remove cotter pin (3) and collar (2). Discard
cotter pin, Fig. 8.
2. Slide governor shaft (1) out of bushings (5).
3. Remove and discard seal (4).
4. Check governor shaft and bushings for wear or
damage.
Replace as required.
Fig. 8





Replace Governor Shaft Bushings
1. Press out upper bushing (2) using Bushing
Driver #19204 (1), Fig. 9.
2. Lubricate new bushing with engine oil. Press in
place with Bushing Driver #19204.
NOTE: Lower bushing is a slip fit. If bearing for
lower bushing (3) is worn, the crankcase
cover must be replaced.
For Briggs & Stratton Discount Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com