User Manual

ManualsBrandsBriggs & Stratton ManualsGeneratorsBriggs & Stratton 3500W / 4375W Generator

Not for

Reproduction

Assembly

Your generator requires some assembly and is ready

for use after it has been properly serviced with the

recommended oil and fuel.

If you have any problems with the assembly of your

generator, please call the generator helpline at

1-800-743-4115. If calling for assistance, please

have the model, revision, and serial number from the

identification label available. See Features and Controls

for identification label location.

Unpack Generator

1. Set the carton on a rigid, flat surface.

2. Remove everything from carton except generator.

3. Open carton completely by cutting each corner

from top to bottom.

4. Leave generator on carton to install wheel kit.

Shipment Contents

The generator is supplied with:

• Operator’s manual

• Wheel kit

• Oil bottle

Install Wheel Kit

NOTICE Wheel kit is not intended for over-the-road

use.

You will need the following tools to install these

components:

• 13 mm and 18 mm wrench

• Socket wrench with 10 mm and 18 mm sockets

Install the wheel kit as follows:

1. Tip generator so that engine side is down.

2. Slide axle stud (A) through mounting bracket with

threaded end facing out.

3. Insert retaining pin (B) through hole on axle stud.

4. Slide a wheel (C) over axle stud.

NOTICE Be sure to install wheel with raised hub

inboard.

5. Attach wheel to axle stud with a washer (D), lock

washer (E) and nut (F). Tighten with a 18 mm

socket wrench and 18 mm wrench.

6. Repeat steps 2 through 5 to secure second wheel.

7. Line up holes in support leg (G) with holes in

generator frame.

8. Attach support leg using 4 capscrews (H) and 4

hex nuts (J). Tighten with a 10 mm socket wrench

and 13 mm wrench.

9. Return generator to normal operating position

(resting on wheels).