Specifications

4 O L Y M P I A M I L L E N N I U M – T H E N E W S T A N D A R D

W H A T E V E R Y I C E R E S U R F A C E R S H O U L D B E

Maintenance

Procedure

To properly maintain the Olympia Edger follow the engine manufacturer’s maintenance instruction manual, which came

with your Olympia Edger.

Make sure you adhere to the oil specifications, grade and change intervals, air filter service and replacement schedule.

When you replace the spark plug at the appropriate scheduled time, make sure you replace it with the same kind of

spark plug that came with the engine and insure that the gap is set to 0.023 inches.

SAFETY NOTE: Never attempt to adjust the carburetor system!

The Olympia Edger comes equipped with a fully recyclable, non-hazardous material 12-volt electric battery. Please note

the battery on the Olympia Edger should be fully charged prior to use. To prevent deterioration of the battery it should be

stored at room temperature between 15 and 24 degrees Celsius (or 60 and 80 degrees Farenheit). It is important the battery

be fully charged prior to storage.

Spare fuel for the Olympia Edger must be stored in a well-ventilated storage area, which is safe and secure and complies

with all fire and safety regulations.

SAFETY IS YOUR FIRST JOB:

Always keep the edger away from all sources of ignition.

Never allow operators to smoke around the edger or in the

refueling and storage areas.

Never inspect the underside of the edger while the engine is

running or while the spark plug wire is attached.

Before using the OLYMPIA™ Gasoline Edger you first must inspect

the blades to ensure they are undamaged and secured tightly to the

blade plate.

SAFETY NOTE: Prior to inspecting the blade tips make sure

you are wearing protective gloves.

1. With the assistance of a second person, lift the edger onto a

workbench, making sure to lift with the legs not the back.

2. Always remove the spark plug wire first before servicing the edger.

3. Remove the Oil Drain Plug and drain the oil.

4. Re-install the Oil Drain Plug.

(1.6 mm)

Fuel Storage

Battery

Maintenance

Blade

Changing

Procedure