Specifications

2 O L Y M P I A M I L L E N N I U M – T H E N E W S T A N D A R D
3
W H A T E V E R Y I C E R E S U R F A C E R S H O U L D B E
2
O P E R A T I N G P R O C E D U R E
Propane
Powered
Olympia
Edger
WARNING!
All operators of the Olympia Edger must read and familiarize themselves with this parts and service manual. Particular
attention must be paid to the Briggs and Stratton operating and maintenance manual supplied with the Olympia Edger.
Maintenance log must be completed for safe operation and to retain warranty coverage the Olympia Edger must be
properly maintained and in safe working order. If problems occur the edger is to be turned off immediately, and removed
from service until the equipment has been properly repaired and tested.
Prior to each edging operation you must
1. Remove the spark plug wire to prevent accidental starting of the engine.
2. Check that the carbide cutting blades are securely fastened and not damaged.
3. If the blades are damaged remove them and replace them with new blades as per the blade replacement
procedure. (see page 3)
4. Replace the spark plug wire.
Always make sure the arena ventilation system is on and operating properly
prior to starting the Olympia edger.
Always make sure the ice is clear of both members of the public and arena
staff prior to operating the edger.
Safety Glasses, (steel toed) safety boots with proper grips, and proper
ear protection gear must be worn by all staff during edging operation.