Specifications

ii O L Y M P I A M I L L E N N I U M – T H E N E W S T A N D A R D
1
W H A T E V E R Y I C E R E S U R F A C E R S H O U L D B E
Attach the Edger handle to the base using three 3/8" x 1" bolts and lock nuts as shown in fig. A
Place the Depth Selection Lever in the top position. Attach the tie rod end to the lower adjusting bracket using the 3/8 x 1 1/4
bolt, washer and lock nut as shown in fig. B (Please note the adjusting rod is preset to the proper length)
Mount the propane tank bracket on the base of the handle uising the two 1/4 x 3/4 screws and lock nuts as shown in fig. C
Check and add oil if necessary to engine.
Place full propane tank on bracket and secure with lock screws, and attach gas regulator.
Connect the electric leads as shown in fig. D
Assembly
Instructions
Olympia
Propane
Edger
A
B
C
D
1
A S S E M B L Y