Specifications

64
3
3. Remove the screws holding the control
bracket ([A] Fig. 11).
Fig. 11
4. Remove the clamp that secures the
governor lever to the shaft.
Control Bracket Removal
(161400)
1. Remove governor lever.(A).
2. Disconnect springs and links (B) from
governor lever.
3. Remove head bolts (C) that secure the
control bracket to the cylinder head. When
baffle is removed, re-install the bolts hand
tight.
4. Remove the oil fill tube screw.([D] Fig. 12)
5. Remove control bracket screws.([E] Fig.
12).
Fig. 12
6. Remove the wire from the Oil Gard®
terminal and the stop switch.
Control Bracket Removal
(260700, 261700)
NOTE: For better access to the control bracket,
remove the oil filter adapter first. SEE SECTION
3- OIL FILTER ADAPTER.
1. Remove the links and springs from the
governor lever ([A] Fig. 13).
Fig. 13
2. Loosen governor lever screw and nut ([B]
Fig. 13).
3. Remove control bracket screws ([A] Fig.
14).
Fig. 14
Disconnect ground wires and remove the
connector from the bracket.