Specifications

63
3
7. Remove the two screws that hold the rear
housing mounting bracket ([B] Fig. 8).
Fig. 8
8. Remove inner blower housing and set
aside.
CONTROL BRACKETS
Control Bracket Removal
(050000, 085400, 086400, 115400,
117400, 118400, 138400, 185400,
235400, 245400)
Control brackets on these models are
incorporated into the blower housing.
To remove the governor lever for the models
listed above, refer to Fig. 9 and follow the steps
outlined below:
1. Hold the governor lever and remove the
upper nut (A) securing the governor lever.
CAUTION: Do not bend the governor shaft cotter
pin while removing the top or bottom governor
lever nut.
2. Remove the lower nut (B) and set aside.
CAUTION: 085400, 086400, 115400, 117400,
138400, 185400,235400, 245400 have left-hand
threads on the governor shaft.
Fig. 9
NOTE: Leave the cotter pin ([C] Fig. 9) in the
governor shaft to prevent it from falling into the
cylinder.
Control Bracket Removal
(104700)
Part of the control bracket must be removed
during the removal of the carburetor. SEE
SECTION 5- CHOKE BRACKET.
The rest of the control bracket assembly cannot
be disassembled until the flywheel is removed.
SEE SECTION 3- FLYWHEEL REMOVAL.
With the flywheel removed:
1. Remove the alternator (if equipped)
assembly ([A] Fig. 10).
2. Remove the back plate ([B] Fig. 10).
Fig. 10