Specifications

110
5
Fig. 68
If not parallel:
• Replace the fuel inlet valve, float and
hinge pin.
19. Install the emulsion tube (A) and then the
main jet ([B] Fig. 69).
Fig. 69
20. Position bowl drain (A) as shown, Fig.69.
21. Install float bowl (B), washer (C), and
mounting screw (D), to carburetor.
22. Tighten screw ([D] Fig. 70) securely.
Fig. 70
Identifying Main Jets (104700)
Carburetor Service - Mikuni
(161400)
CAUTION: Do not use wires, drills or other
devices to clean out metering holes and
passages.
NOTE: Use compressed air at a moderate
pressure setting (5-7 PSI). Blow in both
directions to clean out all openings and
passages.
Model Series Standard Jet High Altitude Jet
Before
90091033
100 92.5
After
90090933
107.5 102.5