Product Manual

5. Place accessory tray (A) over holes (C) on handle
(viewing from front of unit). Push the tree clips (B) into
the holes until they sit flat against the accessory tray.
6. Insert “L” bolt (D) through hole just below accessory
tray on right side of handle (viewing from front of unit).
Hold “L” bolt in place and attach a plastic knob (E)
from inside of unit. Tighten by hand.
7. Insert supplied accessories in spaces provided in
accessory tray. See How to Use Accessory Tray.
Attach Detergent Siphon Hose to Pump
Attach detergent siphon hose (F) to barbed hose fitting (G)
on pump.
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
NOTICE Any attempt to crank or start the engine before it
has been properly filled with the recommended oil will
result in equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
• Refer to engine operator’s manual and follow oil and
fuel recommendations and instructions.
NOTICE Check oil often during engine break–in. Refer to
engine operator’s manual for recommendations.
Connect Hose and Water Supply to Pump
NOTICE DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTICE Remove and discard the shipping caps from the
pump’s high pressure outlet and water inlet before attaching
hoses.
1. Uncoil high pressure hose and attach one end of hose
to base of spray gun. Tighten by hand.
8 BRIGGSandSTRATTON.COM
A
B
C
D
E
G
F
WARNING The high pressure stream of water that
this equipment produces can cut through skin
and its underlying tissues, leading to serious
injury and possible amputation.
• NEVER connect high pressure hose to nozzle extension.
• Keep high pressure hose connected to pump and spray gun
while system is pressurized.
• Always be certain spray gun, nozzles and accessories are
correctly attached.