Generator Systems N o R tf ep o r ro du ct io n Operator’s Manual Generator System
Thank you for purchasing this quality-built Briggs & Stratton® home generator. We’re pleased that you’ve placed your confidence in the Briggs & Stratton brand. When operated and maintained according to the instructions in this manual, your home generator will provide many years of dependable service. This manual contains safety information to make you aware of the hazards and risks associated with home standby generators and how to avoid them.
Table of Contents Important Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . 4 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 For the Home Owner: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 For the Installing Dealer/Contractor: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Owner Orientation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Save These Instructions Important Safety Instructions SAVE THESE INSTRUCTIONS - This manual contains important instructions that should be followed during installation and maintenance of the generator and batteries. Safety Symbols and Meanings Fire Electrical Shock Toxic Fumes Rotating Parts Hot Surface WARNING The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects, or other reproductive harm.
• • • • • • • • • • • • • • n • • • WARNING Propane and Natural Gas are extremely flammable and explosive, which could cause burns, fire or explosion resulting in death or serious injury. DO NOT operate the equipment if the “fuel shut-off” valve is missing or inoperative. Install the fuel supply system according to NFPA 37 and other applicable fuel-gas codes. Before placing the generator into service, the fuel system lines must be properly purged and leak tested.
• • • • • • • CAUTION Installing the 15 Amp fuse could cause the engine to start at any time without warning resulting in minor or moderate injury. • Observe that the 15 Amp fuse has been removed from the control panel for shipping. • DO NOT install this fuse until all plumbing and wiring has been completed and inspected. 6 NOTICE Improper treatment of generator can damage it and shorten its life. • Use generator only for intended uses.
Installation For the Home Owner: Only current licensed electrical and plumbing professionals should attempt home generator system installations. Installations must strictly comply with all applicable codes, industry standards and regulations. Your home generator is supplied with this “Operator’s Manual” and a separate “Installation Manual”. These are important documents and should be retained by the owner after the installation has been completed.
Fuel Factors N o R tf ep o r ro du ct io An important consideration affecting the entire installation is the type of fuel used by your generator. The system was factory tested and adjusted using either natural gas or liquid propane (LP vapor).
A WARNING Running engine gives off carbon monoxide, an odorless, colorless, poison gas. Breathing carbon monoxide could result in death, serious injury, headache, fatigue, dizziness, vomiting, confusion, seizures, nausea or fainting. • Operate this product ONLY outdoors in an area that will not accumulate deadly exhaust gas.
Delivery Inspection Carefully inspect the generator for any damage that may have occurred during shipment. If loss or damage is noted at time of delivery, have the person(s) making delivery note all damage on the freight bill and affix his signature under the consignor’s memo of loss or damage. If loss or damage is noted after delivery, separate the damaged materials and contact the carrier and your installer for claim procedures. Missing or damaged parts are not warranted.
Controls 8kW Generator Read this Operator’s Manual and Important Safety Instructions before operating your generator. Compare the illustrations with your generator to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference. E F D A G N o R tf ep o r ro du ct io B n C Generator is shown with roof and access covers removed for clarity. (A) - Lifting Holes — Provided at each corner for lifting generator.
10kW Generator Read this Operator’s Manual and Important Safety Instructions before operating your generator. Compare the illustrations with your generator to familiarize yourself with the locations of various controls and adjustments. Save this manual for future reference. F E D B A N o R tf ep o r ro du ct io n G Generator is shown with roof and access covers removed for clarity. (A) - Lifting Holes — Provided at each corner for lifting generator.
Access Ports The generator is equipped with an enclosure that has several access panels, as shown. (A) Front Panel that is used to access: • Battery Compartment • Engine Oil Drain Hose • Engine Oil Filter • Engine Valve Cover • Spark Plugs A N o R tf ep o r ro du ct io n Each generator is shipped with a set of identical keys.
To remove roof: 1. Remove the five screws (A) that secure the roof to the unit. A 2. Carefully lift and remove roof from unit. B N o R tf ep o r ro du ct io 1. Remove the two screws (B) that secure the panel to the unit. C 2. Lift and flex panel outward and off base. Use caution not to damage the battery box (C). To secure front panel: 1. Place panel in unit. 2. Secure the panel with two screws.
System Control Panel Compare this control panel illustration with your generator to familiarize yourself with the location of these important controls: F MENU A ESC E D N o R tf ep o r ro du ct io n B AUTO C OFF A - Menu/Programming Navigation Buttons — See Menu section for details B - USB Port — Authorized Dealer Service Use Only C - Generator Operation Control Buttons — •“AUTO” Normal operating position. Press and hold button to put unit into Automatic mode.
Menu The following chart shows the icons for the buttons that control the system control panel. ENTER THE MENU (VIEW SETTINGS) PRESS TO CONFIRM SELECTION WHEN PROGRAMMING. MENU ESCAPE (EXIT) RETURN TO LAST MENU ITEM RIGHT ARROW TOGGLE THROUGH MENU OPTIONS SETTING SYSTEM PARAMETERS LEFT ARROW TOGGLE THROUGH MENU OPTIONS SETTING SYSTEM PARAMETERS USED TO MANUALLY START THE GENERATOR. PRESS AND HOLD BUTTON TO START THE GENERATOR.
General Set Up Screen For general set up, press and hold the left arrow and right arrow for 3 seconds. Follow the prompts as outlined below. NOTE: Date and Time were set at the factory and stored in the control panel memory. The Exercise Cycle was also set at the factory. The default exercise cycle occurs on Tuesdays, at 2:00 P.M. Central Standard Time. To update or change these settings, follow the steps below.
Control Panel Prompts Automatic Mode In Automatic Mode, the display screen will display via scrolling text: • GENERATOR READY - if the unit is in standby and utility power is present. • GENERATOR ON - if the unit is running and utility power is not present. • SERVICE CODE - if a system service code has been detected.
Operation Automatic Operation Sequence Important Owner’s Considerations Engine Oil The generator’s control board constantly monitors utility voltage. Should utility voltage drop below a preset level, the control board will signal the engine to crank and start. CAUTION With the system switch set to AUTO, the engine could crank and start at any time without warning, resulting in minor or moderate injury.
Setting Exercise Timer N o R tf ep o r ro du ct io To set the exercise timer: NOTICE The generator is set with a deservice code exercise cycle setting of Tuesday at 2:00 P.M, Central Time. To change the cycle setting, proceed to the following steps: 1. Choose the day and time you want your generator to exercise. 2. Press and hold the left arrow and right arrow simultaneously for 3 seconds to enter the General SetUp program mode. See General Set-Up flow chart in Menu Section. 3.
Servicing the System Before performing any generator maintenance, always perform the following steps: 1. Set generator’s circuit breaker to its OFF position. 2. Press and hold the control board OFF button. 3. Remove 15 Amp fuse from control board. 4. Utility voltage is present at generator control board. Disconnect power before servicing control board by removing the fuses from the transfer switch. 5.
n High Oil Temperature This service code is indicated by High Oil Temperature scrolling across the digital display. The contacts of the temperature switch are normally open. If the engine temperature increases past a determinded temperature, the service code is detected and the engine shuts down. Common causes for this condition include running the unit with access panels removed, obstructed air inlet or exhaust port, or debris in the engine compartment or running unit with roof open.
Maintenance Schedule Follow the hourly or calendar intervals of operation, whichever occurs first. First 5 Hours Generator Maintenance WARNING Unintentional sparking could cause fire or electric shock resulting in death or serious injury. When adjusting or making repairs to your generator • Disconnect the spark plug wire from the spark plug and place the wire where it cannot contact spark plug.
Engine Maintenance Battery WARNING Battery posts, terminals and related accessories contain lead and lead compounds, chemicals known to the State of California to cause cancer and reproductive harm. Wash hands after handling. Servicing of batteries is to be performed or supervised by personnel knowledgeable of batteries and the required precautions. Keep unauthorized personnel away from batteries. Servicing the Battery If it is necessary to service the battery, proceed as follows: 1.
Engine Oil Checking/Adding Engine Oil The engine is filled with synthetic oil (API SJ/CF 5W-30). This allows for system operation in the widest range of temperature and climate conditions. We recommend the use of Briggs & Stratton Warranty Certified oils for best performance. Other high-quality detergent oils are acceptable if classified for service SJ or higher. DO NOT use special additives. Outdoor temperatures determine the proper oil viscosity for the engine.
CAUTION Avoid prolonged or repeated skin contact with used motor oil. • Used motor oil has been shown to cause skin cancer in certain laboratory animals. • Thoroughly wash exposed areas with soap and water. KEEP OUT OF REACH OF CHILDREN. DON’T POLLUTE. CONSERVE RESOURCES. RETURN USED OIL TO COLLECTION CENTERS. NOTICE Any attempt to crank or start the engine before it has been properly serviced with the recommended oil will result in equipment failure.
Fuel System Inspection and Maintenance Service Spark Plugs Natural Gas/Propane Fuel System The fuel system installed on this engine has been designed to various standards to ensure performance and reliability. To ensure compliance to these standards, follow the recommended maintenance schedule contained in this section. NOTICE The fuel system components have been specifically designed and calibrated to meet the fuel system requirements of the engine.
Troubleshooting Engine is running, but no AC output is available. Engine runs well at no-load but “bogs down” when loads are connected. Engine will not start; or starts and runs rough. Loss of power on circuits. Unit will not exercise. Excessive Vibration Odor of fuel Utility power returns, unit does not stop 28 Correction 1. Circuit breaker open or defective. 1. Reset or replace circuit breaker. 2. Service code in generator control board. 2. Contact local service provider. 3.
U.S. EPA, and Briggs & Stratton Corporation Emissions Control Warranty Statement for Emergency Standby Engines Your Warranty Rights And Obligations January 2014 General Information Owner’s Warranty Responsibilities: The U.S. EPA, and Briggs & Stratton (B&S) are pleased to explain the emissions control system warranty on your Model Year 2014 - 2015 engine / equipment. In the U.S., new Emergency Standby Engines must be designed, built, and equipped to meet stringent emission standards.
BRIGGS & STRATTON POWER PRODUCTS GROUP, LLC STANDBY GENERATOR OWNER WARRANTY POLICY LIMITED WARRANTY COVERAGE* Some states or countries do not allow limitations on how long an implied warranty lasts, and some states or countries do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation and/or the above exclusion may not apply to you.
ABOUT YOUR WARRANTY 2. 3. Normal Wear and Maintenance: Outdoor Power Equipment and engines, like all mechanical devices, need periodic parts and service to perform well. This warranty does not cover repair when normal use has exhausted the life of a part or the equipment. Typical wear items include engine oil, oil gauges, o-rings, filters, fuses, spark plugs, anti-freeze, starting batteries, etc.
n N o R tf ep o r ro du ct io This page intentionally left blank.
Generator Specifications 10kW Watt Rated Maximum Load Current* (at 25°C/77°F, LP)*: at 240 Volts........................................................ 41.7 Amps Rated AC Voltage.............................................. 120/240 Volts Phase.................................................................. Single phase Rated Frequency........................................................ 60 Hertz Generator Breaker.......................................................50 Amp Normal Operating Range....
316793 Rev.
