Installation & Operating Guide

38
For the following tests, the operator requires objects to be placed in the sensor’s detection
areas or an assistant (to observe the host activity).
5) Verify each accuracy of detection distance: Starting from the outside of the detection area,
the operator should check several points along the centre line of the detection width down
to around 0.4m distance from each sensor. The operator should note down the distance at
which host system functions occur and verify that these are in line with the system
configuration for this vehicle.
6) Close detection behaviour: Verify objects in between 0.3m and 1.3m distance are only
detected if they move relative to that sensor.
7) Very close detection awareness: Verify objects less than 0.3m from each sensor are not
detected.
8) Similar to the previous tests the operator should scan all the edges of the detection area
according to the installed system or configuration for this vehicle. They should note down
the detected locations and check if they match with the detection area set when this
Brigade Backsense
®
System was installed on this vehicle.
9) During the test the operator should verify that each detection zone LED on the Backsense
display is illuminated, this will ensure the correct distance of the detected object is
indicated to the driver.