Installation manual

TM
Network Management Manual
580-00511, rev B 30 of 34
8.1 Radio Unit Web Browser SNMP Set Up
SNMP System Group Setup
The System Group variables fields may be populated with any desired name(s),
descriptions, locations and appropriate system contact for maintenance purpose.
1. System OID: 1.3.6.1.4.1.6080.1.2.3
BridgeWave’s identification of the network management subsystem
contained in this entity.
2. System Name:
Typically an administratively assigned name for this managed node. By
convention, this is the node's fully-qualified domain name.
3. System Description:
Typically the full model name and version
4. System Location:
Typically the physical location of this radio (address, building name…)
5. System Contact:
Identification of the contact person for this managed node, together with
information on how to contact this person
Trap Destination
Enter the information for the SNMP management station to which trap messages
should be sent. The three fields listed below are required for proper configuration
of each desired trap destination(s).
1. IP Address: The IP address destination of the host to receive traps
2. Host name: The trap host name
3. Community string: Value required by SNMP management station
8.2 Software and Tools
BridgeWave supplies an enterprise MIB file that provides definitions of objects
beyond the standard MIB-2 objects. This MIB file can be found on the CD that is
included with the product and on BridgeWave’s website under the Support section.
To install the BridgeWave MIB file on your network management station, follow the
instructions provided with your network management station software. Note that
standard MIB-2 objects can be accessed without installing the BridgeWave MIB file.