Installation manual

TM
Network Management Manual
580-00511, rev B 20 of 34
5.1 User
Permits viewing of unit status, configuration parameters and statistics. Does not
permit modification of any parameter, setting passwords or performing maintenance
functions. The user password can be set and recovered by the administrator. The
factory default user name password combination is: user/userpass
Password: The password is case-sensitive and can have 0 to 16
alphanumeric characters.
Confirm Password: Repeat the same password; keep in mind that the password
is case sensitive.
5.2 Administrator
Permits full access to unit, including configuration and maintenance. In order to
recover a lost administrator password a hard reset I required. This will reset the unit
to factory default values and requires a complete reconfiguration of the unit. The
factory default user name and password combination is: admin/adminpass
Password: The password is case-sensitive and can have 0 to 16
alphanumeric characters.
Confirm Password: Repeat the same password, keep in mind that the password
is case sensitive.
5.3 Factory Access
Permits factory service personnel to access the unit, including factory-only internal
settings. In order for service personnel to access unit, feature must be enabled and the
administrator needs to set and provide the assigned password.
Password: The password is case-sensitive and can have 0 to 16
alphanumeric characters.
Confirm Password: Repeat the same password, keep in mind that the password
is case sensitive.
Factory Access: Scroll menu to choose between enable and disable, default
is for the access to be disabled.
NOTE: The administrator should only enable factory access for the time of active
access by factory service personnel.