Installation manual

Network Management Manual

580-00511, rev B 2 of 34

No portion of this publication may be reproduced, copied, or distributed without the

written consent of BridgeWave Communications. BridgeWave reserves the right to

update or change the material in this publication at any time without notice. BridgeWave

has made every effort to ensure that the information and the instructions contained in the

publication are adequate and is not responsible for any errors or omissions due to typing,

printing, or editing of this document.

Purchasers of BridgeWave products should make their own evaluation to determine the

suitability of each such product for their specific application. BridgeWave’s obligations

regarding the use or application of its products shall be limited to those commitments to

the purchaser set forth in its Standard Terms and Conditions of Sale for a delivered

product.

This publication has been prepared for professional and properly trained personnel, and

the customer assumes full responsibility when using the information herein.

Safety

CAUTION, WARNING, and DANGER statements have been strategically placed in the

text to alert personnel of possible hazards. These statements must be closely observed.

The following general safety precautions must be observed during all phases of operation

and service of the products covered in this manual. Failure to comply with these

precautions or with specific warnings elsewhere in this manual willfully violates

standards of design, manufacture, and intended use of the product. BridgeWave assumes

no liability for the customer’s failure to comply with these requirements.

• The products meet all applicable FCC safety requirements for general population

exposure to radio frequency emissions; however, as a general principle it is best

to avoid prolonged, unnecessary exposure to the front of any radio’s transmitting

antenna while it is operating.

• The outdoor equipment must be properly grounded to provide protection against

voltage surges and built-up static charges. In the event of a short circuit,

grounding reduces the risk of electrical shock.