Installation manual

TM
Network Management Manual
580-00511, rev B 18 of 34
Load Defaults: Displays the factory default settings in the data entry fields
of the page. These settings will only become active if the
submit new values button is then clicked, followed by a
system restart.
Submit New Values: Submits changes to memory. Any changes made without
clicking this button will be lost upon leaving the Setup web
page. In order to activate any submitted changes from the
Setup page, the unit must be restarted or power cycled.
5. Passwords
This web page allows the Administrator to set the User, Administrator and Factory
Access passwords and SNMP community names. The changes take effect
immediately upon clicking the Submit buttons. It is important to remember the
passwords that have been assigned to the unit. If a password is forgotten, it cannot be
recovered; if this happens please refer to the Factory Reset section below.