Installation manual

TM
Network Management Manual
580-00511, rev B 17 of 34
DHCP server. Un-checking the box disables the DHCP
function.
Subnet mask: The subnet mask can be configured by picking the desired
value from the pull-down menu.
Default Gateway: Sets the default gateway address for this radio. Use
‘0.0.0.0’ if no default gateway is to be used.
4.4 Link State Propagation
Enable or disable Link State Propagation (LSP). LSP is normally disabled except in
redundant link configurations or when it is necessary to quickly signal external
network equipment when link failures occur. In redundant link configurations LSP
can be enabled to allow for fast switchover if a radio link failure occurs. When
enabled, LSP turns off the transmit laser on the radio fiber interface when the radio
link is down. This in turn allows the external network equipment to rapidly switch
application traffic to another available (redundant) interface, assuming that the
network equipment supports this functionality (generally supported on enterprise and
network backbone class switches and routers).
4.5 Management Access
As a default, management agent access is enabled on all interfaces. It is often
desirable to restrict agent access for security purposes. One interface must be enabled
at all times to ensure access to the unit if troubleshooting becomes necessary.
4.6 Activity buttons
Load Current: Displays the current operating values in the data entry
fields of the page. These are the values as of the last unit
restart and do not reflect any changes that have been
submitted pending a future system restart. In order to
reverse the effect of recently submitted configuration
changes, it is necessary to click load current followed by
clicking submit new values.