Datasheet

AR/GE/FE/U80/80XInstallationManual
17 58000519rev.D
A48VoltDCversionisavailableforthisproduct.Thepower
connectoristhesamebuttheconnectorlocationisslightlymoved.
TheNMS’StatusPage’readingwillstillread24V.
Figure3.7.21: 80GHzpoweranddatacables with
serviceloopforstrainreliefandproperfiberbend
radius.
3.7.3 GroundCabling
Thepreferred methodfo rgro undingtheradiounitistogroundthemasttoagroundsource,since
thisprovidesthelargestgroundingsurfacecontactpossible.Ifthisisnotpossible,thenusethe
followingprocedure:
1. Attachthelugofthegroundcable(notprovided)withtheradiotooneofthetwo#8
holesatthebottomoftheradiousinga#832x½”longbolt, #8lock washerand#8flat
washers(notprovided).
2. Connectotherendofthegroundcabletoanearbygroundlocation.
3.7.4 10/100BaseTSurgeSuppressor
Ifthe10/100BaseTportispermanentlyconnectedtoothernetworkequipment(notnormally
required),itshou ldbeconnectedusingCat5eUTPcablesratedfortheoutdoorand/orindoor
environmentswherethecableswillberun.
Itise ssentialthatthecablingbeconnectedtotheradiounitthroughanEt hernetratedsurge
suppressorinsideoftheplasticbackcoveroftheunit,andasurgesuppressorshouldalsobeusedat
thepointwherethecableentersabuildingorisco nnectedtootheroutdoorequipmentthatdoesnot
alread yconta insurgesuppressionhardware.