Installation Guide

repress and hold the heater icon for 10 seconds again, then the ember bed will also flash
indicang the heater funcon is unlocked and to recover the original states which you have
set.(Note: This can't be set with the remote control).
TIMER
The TIMER has adjustable seng at range from 1 hours to 8 hours and OFF. As shown the
following: 1h-2h-3h-4h-5h-6h-7h-8h-OFF. Once you have set the mer, and the mer is up, it
will close all the funcons and enter standby mode. In this mode, you should touch the power
icon to restart the appliance.
INCREASE/DECREASE BUTTON
The Level Selecon buon is used to adjust the heat seng and the brightness of flame. See
relevant secon for more details.
7
OPERATING INSTRUCTION
On the top-right of the electric firebox is the mechanical control panel. This panel contains the
buons to properly operate the electric fireplace. the buons on the remote control funcon in
the same way. The remote control has an effecve range of up to 6 m.
Digital Display
NOTE: The remote control is intended only for the funconal operaon
of the product, It can not lock/unlock the heang funcon！
POWER
The power buon turns the fireplace on & off. When the fireplace is off, pressing the power
buon once will switch on the fireplace. Once on, if the fireplace display is not illuminated
pressing the power buon will light up the display. If the power buon is pressed again within
10 seconds it will turn off the fireplace. If the display is already illuminated then only one press
of the power buon is needed to turn off the fireplace.
The fireplace has a built-in memory funcon and when turned back on it starts at the last used
sengs (except mer). If the fireplace is disconnected from the main power source, it reverts
to the default sengs.
FLAME
This buon is used to turn flames ON, to alter the flame color and to turn flames OFF. Press
the Flame buon mulple mes to cycle through 7 color opons (L8, L7, L6, L5, L4, L3,L2),
color rotaon opon (L1) and flames OFF.
While L8, L7…or L2 is displayed, press the Level Selecon buon to change the brightness of
the flames from the available opons: 4- brightest, 3-brighter , 2-bright , 1-darkest .
HEATER
The Heater Buon turns the heater On & Off.
With Heat ON and set temperature displayed, press the Level Selecon buon mulple mes
to cycle through the 11 temperature sengs: 82℉-ON - 64℉- 66℉ - 68℉-70℉-72℉-74
℉-76℉-78℉-80℉ (27℃-ON - 18℃-19℃- 20℃-21 ℃-22℃-23℃- 24℃-25℃-26℃).
Temperature unit convert funcon: When the heater is on, press and hold the Power Buon
for 5seconds, current temperature unit display will flash 3 mers and convert to another
temperature unit (Note: This can't be set with the remote control).
Lock & unlock heater funcon: press and hold the Heater Buon for 10 seconds, the ember
bed will flash, indicang that the heater funcon is locked. To unlock the heater funcon, just