Installation Guide

Posion your completed mantel close to its final locaon. Make sure you can access the back of
the mantel as your electric fireplace appliance will be installed from back.
Using a Phillips head screwdriver, remove the screws and the metal mounng center opening.
Next unpack the electric fireplace appliance carefully. Posion the appliance behind the fire-
place with front facing the wood mantel. With the help of an adult assistant, li the appliance
and gently slide it into the opening in the mantel. Make sure the appliance is centered le and
right in the opening. Be careful when placing appliance and adjusng, boom of appliance could
scratch the finish of the base/hearth of your fireplace. Re-aach the mounng brackets with the
Phillips head screwdriver, and supplied screws.
3
REAR VIEW OF FIREPLACE
≥1“
≥1“
≥1.5”
ELECTRIC
FIREPLACE
INSERT
（A）
≥1.5”
≥1“
≥1“
ELECTRIC
FIREPLACE
INSERT
（B）
INSTALLATION INSTRUCTION
DO NOT OVER TIGHTEN. With the help of an
assistant, carefully li completed unit and place
it with the front facing out in the final locaon
you have chosen for your fireplace. Make sure
to secure the electrical cord before liing or
moving completed fireplace. When choosing a
final locaon, make sure you will have clear
access to grounded electrical outlet.
INSTALLING THE EMBER BEDS
If you purchased the electric fireplace with crystals or pebbles, you should installing the ember
beds before you install the fireplace into the mantel.
You will need one phillips head screw-
driver to complete the following instruc-
ons:
1. Remove the 2 screws on the upper
le and upper right corners of the glass
front, then remove the glass front
slightly upward.
2. Carefully remove the glass front.
3. Arrange the ember beds along the
inset window ledge at the front of the
electric fireplace.
4. Replace the glass front.
5. Line up the holes on the front with the
holes on the firebox and insert and
ghten 2 screws to hold the glass front
in place.
5
x2
x2
1
2
43