User Manual

11
LED Behavior
Function
LED Behavior
Description
Power
Continuous Illumination
Normal Operation
Power
Unlit
Power off
Status
Continuous Illumination
Connect to the switch by Ethernet or WiFi
Status
Unlit
1. Power off
2. No connection
Status
Blinking
Data Transmission via Ethernet
Internet
Continuous Illumination
Connect to Internet
Internet
Unlit
1. Power off
2. No Connection
Camera
1/2/3
Blinking
Upgrading firmware
Camera
1/2/3
Continuous Illumination
Firmware is successfully upgraded
Hardware Reset
The Reset Button can be used to reboot the camera or restore it to the factory default
settings. If the camera experiences a problem, rebooting the camera may fix the
problem. If the problem remains, please restore the camera to the factory default
settings and reinstall the
software.
 To Reboot − Press and hold the Reset Button for one second using a paper clip or
thin object. Wait for the camera to reboot.
 To Restore − Press and hold the Reset Button for ten seconds until the LED light
turns off. When it is successfully restored, the LED will be blue during the normal
Reset Button