Owner manual

from 1 frame to 15 frames.

NOTE- Make sure SMTP configuration has been completed.

Refer to Mail for further details.

e. Send HTTP notification

Check this item, select the destination HTTP address, and specify

the parameters for event notifications by <Motion Detection>

triggered. When an alarm is triggered, the notification can be sent to

the specified HTTP server.

For instance, if the custom parameter is set as” action=1&group=2”,

and the HTTP server name is” http://192.168.0.1/admin.php”, the

notification will be sent to HTTP server as”

http://192.168.0.1/admin.php?action=1&group=2” when alarm is

triggered.

f. Record stream to SD Card

Select this item and the Motion Detection recording will be stored in

Micro SD / SDHC card when motion is detected.

Pre-trigger buffer recording function allows users to check what

happened to cause the trigger. The pre-trigger buffer time range is

from 1 to 3 seconds. Select <Upload for __ sec> to set the recording

duration after motion is triggered. The setting range is from 1 to 99999

seconds. Select <Upload during the trigger active> to record the

triggered video until the trigger is off.

NOTE- Please make sure the local recording (with Micro SD /

SDHC card) is activated so that this function can be implemented.

Refer to Recording for further details.

D. File Name

The uploaded image’s filename format can be set in this section. Please

select the one that meets your requirements.

E. Save

Please click on the <Save> button to save all the Motion Detection settings

mentioned above.