Owner's Manual User guide

The Reverb Parameters
• Reverb LF RT MPY:
Control Range: .2 – 4.0 x
Sets the low frequency reverb time below the crossover frequency set by the Reverb LF
XOVER control. Displayed and controlled as a scaling of the Reverb Time control.
• Reverb LF XOVER:
Control Range: 80 Hz – 4.8 kHz
Sets the crossover frequency used by the Reverb LF RT MPY control.
• Reverb VLF Cut
:
Control Range: 0 – -18 dB
Cuts the very low frequency content of the initial part of both the early and late reverberant
fields.
• Early/Reverb Mix:
Control Range: 0-20 / 0-20
Sets the balance between the early and later parts the reverberant fields.
• Early Rolloff:
Control Range: 80 Hz – 20 kHz
Sets the rolloff frequency point of the low pass filter for the early part of the reverberant field.
• Early Select:
Control Range: 0 – 20
Controls the build up and decay characteristics of the early part of the reverberant field.
Table of all user reverb parameters as they appear in the menu:
Reverb Time Size Pre Delay Diffusion Density
Modulation Rolloff HF RT
Multiply
HF RT
Crossover
LF RT
Multiply
LF RT Crossover VLF Cut Early/Reverb
Mix
Early Rolloff Early Select
3-3