Installation Guide

BREWER TESTING

Testing

Once BREW EXPRESS has been installed into the rough-in-box it must be tested to ensure proper operation.

1. Turnonelectricalpowerandpowerswitch(locatedontopofbrewer).Thebrewbuttoniconshouldbeilluminated.

If the button icon is not illuminated, refer to the troubleshooting section of this manual.

2. Turn on water supply to BREW EXPRESS. There should be no leaks in the water connections. If water is

leaking, pull the brewer from the wall, check connections and refer to the troubleshooting section of this manual

to make appropriate corrections. If water is leaking from inside the brewer, disconnect from the rough-in-box

and contact customer service.

Test the Brewer

1. Place empty brew basket in unit.

2. Place the empty carafe under brew basket.

3. Pressthe“Brew”button.

4. Afteramomentwaterwillbeginowingandremainonfor140to180seconds(dependinguponmodel).

5. ABeeperwillsound40secondsafterwaterstopsowing.

SeeOperationGuidefrommoredetailedinformationonoperatingtheBrewExpress.Also,thisguidecontains

a trouble shooting section if needed.