Installation Guide

5. Bring1/4”water supply line to cut opening. Bring water
line through grommet in rough-in-box (See Supply Detail).
 Sliderough-in-boxintoopeningwhilepullingabout18”of
water line through grommet hole. Secure rough-in-box to wall
stud with sheet rock screws.PURGEWATERLINEbyrunning
water to clean any possible debris. Cut water line to length
 (approx.3”)insiderough-in-box and attach male quick
connector. Use wrench to tighten and secure.
See Male Connector Detail and figures 5 and 7.
IMPORTANT:
Water line to brewer must be flushed and a filter installed.
Should debris or calcium from hard water clog brewer system
ALL WARRANTIES VOID. Check for leaks.
To prevent this from happening, install water lter to waterline.
4. Place rough-in-box on a towel or cardboard to protect
counter surface. Bring power supply wire from source to cut
opening as shown in Figure 4.Minimum12-2wirerequired.
Besuretohaveanadditionallengthofapproximately18”at
rough-in-box opening for installation of box. Remove power
panel cover. Install strain relief(notsupplied)inhole.Run
power supply wire through strain relief and secure power
supply wire (See Supply Detail, page 11).Connectpower
supply wires to power panel supply wires and secure with
wire nuts (See Wiring Detail, page 11).Connectgreen wire
to green wire, black to black and white to white.
12
BREWER INSTALLATION
Figure 5
Supply Detail Wiring Detail
Male Connector Detail
Figure 4