Instructions for use

preparing the BRITA

MAXTRA

cartridge

1. Remove the cartridge from its wrapping (it is normal

for the cartridge to appear moist during storage).

2. Immerse the cartridge in cold water and shake gently

to remove any air bubbles. There is no need to pre-

soak this cartridge before use.

3. Insert the cartridge into the lter funnel and push it

rmly into place. When correctly tted, the cartridge

should remain in place when the funnel is turned

upside-down.

4. Fill the lter funnel with cold tap water and allow it

to lter through, then discard the water. Repeat this

process, again discarding the water.

5. Rell the lter funnel with water - the BRITA

MAXTRA

cartridge is now ready for use. You do not

need to keep the lter cartridge immersed in water.

• Always make sure that you have MAXTRA

spare

cartridges to hand. When buying new cartridges

look for the BRITA

MAXTRA

lter on the cartridge

packaging.

• When it is time to replace the BRITA

MAXTRA

lter

cartridge after 4 weeks use, simply lift the handle

on top of the cartridge and pull upwards to remove.

BRITA

cartridges are 100% recyclable. Visit www.

brita.co.uk or call the BRITA

Care team for further

information on participating retailers.

• Repeat steps 1-5 with a new cartridge.