Instructions for use
6
preparing the BRITA
®
MAXTRA cartridge
1. Remove the cartridge from its wrapping (it is normal
for the cartridge to appear moist during storage).
2. Immerse the cartridge in cold water and shake gently
to remove any air bubbles. There is no need to pre-
soak this cartridge before use.
3. Insert the cartridge into the lter funnel and push it
rmly into place. When correctly tted, the cartridge
should remain in place when the funnel is turned
upside-down.
4. Fill the lter funnel with cold tap water and allow it
to lter through, then discard the water. Repeat this
process, again discarding the water.
5. Rell the lter funnel with water - the BRITA
®
MAXTRA cartridge is now ready for use. You do not
need to keep the lter cartridge immersed in water.
• Always make sure that you have MAXTRA
spare
cartridges to hand. When buying new cartridges
look for the BRITA
®
MAXTRA
lter on the cartridge
packaging.
• When it is time to replace the BRITA
®
MAXTRA lter
cartridge after 4 weeks use, simply lift the handle
on top of the cartridge and pull upwards to remove.
BRITA
®
cartridges are 100% recyclable. Visit
www.brita.co.uk or call the BRITA
®
Care team for
further information on participating retailers.
• Repeat steps 1-5 with a new cartridge.