User Manual

18
t
Troubleshooting
Before carrying out any of the following service checks, unplug the FoodCycler from the mains.
PROBLEM WHAT TO DO
FoodCycler will not start
•
Check that the power plug is connected to a
power outlet and the outlet is turned on.
•
Check that your FoodCycler is assembled
correctly.
Power light
-Flashing & FoodCycler beeps
- Flashing and FoodCycler does not operate
- No light
•
Lid unlocked/sensor dislodged
•
Require manual reset
•
No power, check connection
Any Indicator Lights
-Flashing & FoodCycler stops processing
-No Light
•
Motor overloaded. Check any food jam inside
the bucket. Remove some of the food scraps from
bucket.
NOTE: It only applies to the drying light.
•
No power, check connection
Contact Breville Customer Service Centre if the
problem still exists. It may be component issue on
FoodCycler.
Excessive noise
•
Check that your FoodCycler is on a level surface
A Manual Reset is necessary if your FoodCycler operating system needs to be reset to an earlier
mode following a minor malfunction.
Follow these instructions to properly complete a manual reset:
1. Plug FoodCycler in.
2. Press and hold the Power On/Off button for 3 seconds, until you hear a beep and the
FoodCycler shuts off.
3. Unplug your FoodCycler for 1 minute.
4. Plug your FoodCycler back in and wait ten seconds.
5. Press the Power On/Off button as you normally would to start a cycle.
If the Manual Reset does not work the first time, try resetting again.
n
NOTE
If your FoodCycler is signalling a components issue, do not continue using.
Contact Breville Customer Service Centre.