the Smart Dry™ Dehumidifier & the Smart Dry Plus™ Dehumidifier Instruction Book - LAD200 & LAD300 LAD300_200_ANZ_IB_B19.
Contents 2 6 7 8 8 9 12 14 Breville Recommends Safety First Components Control Panel Features Assembly Functions Care, Cleaning & Storage Troubleshooting BREVILLE RECOMMENDS SAFETY FIRST At Breville we are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer, foremost in mind. In addition, we ask that you exercise a degree of care and adhere to the following precautions.
• Do not run the power cord under carpeting or cover the cord with rugs, runners or the like. Arrange the cord away from traffic areas and where it will not be tripped over. • Do not route the power cord under furniture or appliances. • To protect against electrical hazards, do not immerse any part of the dehumidifier in water or other liquids. Do not use the dehumidifier in the immediate surroundings of a bath, shower or swimming pool. • Water in the water tank is not suitable for drinking.
All servicing should be performed by qualified personnel only. • If the dehumidifier ever tips or falls over when the water reservoir is full, immediately unplug the power cord. Ensure the unit is dried thoroughly before resuming operation. • Keep the dehumidifier and dust filters clean. Follow the cleaning instructions provided in this book.
• Any maintenance other than cleaning should be performed at an authorised Breville Service Centre. • This appliance is for household use only. Do not use this appliance for anything other than its intended use. Do not use in moving vehicles or boats. Do not use outdoors. Misuse may cause injury. • The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances.
Components Front Back A B C D E F G A. B. C. D. E. F. G. Control Panel Air Outlet Carry Handles Housing Body Air Inlet and Filter Water Tank Continuous Drainage Outlet Not pictured Power Cord Drainage Hose (gravity-fed) Wheels Carbon Filter Water Level Indicator Water Tank Lid (LAD300 only) 6 LAD300_200_ANZ_IB_B19.
Control Panel A F B LOW G H HIGH DEFROST EMPTY ME SPEED C D I NIGHT TIMER MODE HUMIDITY SETTING J E A. B. C. D. E. F. G. H. I. J. Fan Speed Low & High Fan Light Timer Night Mode Humidity Setting Mode Defrost Light Empty Me Light Power On/Off Display Screen Display Screen Icons Relative Humidity Level (%) Timer Ventilation Mode Laundry Continuous Dehumidification Auto Dehumidification 7 LAD300_200_ANZ_IB_B19.
Features Assembly WHAT IS A DEHUMIDIFIER? BEFORE FIRST USE Your Breville dehumidifier is designed to reduce and maintain the level of humidity in the air, as well as to prevent condensation and mildew on the ceilings and walls. 1. Before using your dehumidifier for the first time, remove all packaging material and promotional labels. 2. Check for any missing or damaged parts as per the components list. 3. Clean all parts according to the Care, Cleaning & Storage section of this book. 4.
Functions USING YOUR BREVILLE DEHUMIDIFIER 1. To operate the dehumidifier, press the POWER button. 2. The icon for the last mode used will illuminate on the display screen or another mode can be selected. 3. If in Auto mode, adjust the humidity level if desired (see Humidity Setting). 4. The unit will start to operate within 5 seconds. 5. Press the POWER button again to turn off. NOTE The dehumidifier cannot operate if the water tank is full or is not installed correctly.
NOTE The fan will only operate on Low speed in Continuous mode and on High speed in Laundry mode. NIGHT MODE The night mode will automatically turn off all lights on the control panel (except the Night button light) and operate in the last setting. 1. Press the NIGHT button on the control panel. 2. Within 5 seconds, the lights on the control panel will turn off, except the NIGHT button light. 3. Press once to view current humidity level. 4. Press the NIGHT button twice to exit Night mode.
CONTINUOUS DRAINAGE (hose drainage using gravity) The continuous drainage outlet allows water to drain without having to monitor and empty the water tank. Ensure the hose (included) is properly inserted before starting the dehumidifier. Drainage hose connection outlet DEFROST This dehumidifier is equipped with an automatic defrost. The evaporator may start auto-defrosting if operating in a room temperature that is less than 23°C. 1. If the DEFROST light turns on, defrosting has automatically started.
Care, Cleaning & Storage WARNING Before cleaning or maintenance of the dehumidifier, ensure the power is switched off at the outlet and the plug is removed. WATER TANK CLEANING NOTE The dehumidifier cannot operate if the tank is full or is not installed correctly. Clean the water tank once a week if used regularly. 1. Remove the water tank from the back of the dehumidifier by holding the sides and pulling outwards. CLEANING YOUR DEHUMIDIFIER 1. Keep the unit upright when cleaning. 2.
FILTER CLEANING The air inlet grille at the back of the dehumidifier also acts as the filter holder. The filter includes a mesh dust filter to capture larger airborne particles, and a black carbon filter for finer debris and to help reduce odours and smoke. 2. To separate the mesh dust filter from the grille, pull outwards using the tab in the middle of the filter to disengage from the clips on the grille.
Troubleshooting TROUBLESHOOTING GUIDE Before carrying out any of the following service checks, unplug the unit from the power outlet. PROBLEM POSSIBLE CAUSES WHAT TO DO Not working. • Power plug is disconnected. • Plug the power cord into the power • The tank is full of water. • The tank is not in the right • Empty the water tank. • Position the water tank correctly in the • The filter is too dirty. • Clean the filter. position. Dehumidification strength has decreased. socket. unit.
ERROR CODES ERROR CODE E2 is on the display screen. E3 is on the display screen. E6 is on the display screen. POSSIBLE CAUSES WHAT TO DO • The humidity sensor is not • Contact Breville customer service. • There is damage to the • Contact Breville customer service. • The pump is not working. • Contact Breville customer service. working. automatic defrost sensor. 15 LAD300_200_ANZ_IB_B19.
Breville Customer Service Centre Australian Customers New Zealand Customers Phone: 1300 139 798 Phone: 0800 273 845 Web: Web: www.breville.com www.breville.com Breville, the Breville logo, Master Every Moment, Smart Dry, Smart Dry Plus and SenSair are trademarks of Breville Pty. Ltd. A.B.N. 98 000 092 928. Copyright Breville Pty. Ltd. 2019. Due to continued product improvement, the products illustrated/photographed in this booklet may vary slightly from the actual product.
