the Perfect Press™ Instruction Book - BSG600
Contents 2 8 9 11 Breville Recommends Safety First Components Functions Care & Cleaning BREVILLE RECOMMENDS SAFETY FIRST At Breville we are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer, foremost in mind. In addition we ask that you exercise a degree of care when using any electrical appliance and adhere to the following precautions.
• Remove and safely discard any packaging material and promotional labels before using the grill for the first time. • To eliminate a choking hazard for young children, remove and safely discard the protective cover fitted to the power plug of this appliance. • Do not place the grill near the edge of a bench or table during operation. • Ensure the surface is level, clean and free of water and other substances. • Do not use the grill on a sink drain board.
• When operating the grill, ensure the power cord is kept away from any heat source including the surface of the grill. Ensure the power cord does not become trapped between the upper and lower hot plates of the appliance during use and storage. • Do not attempt to operate the grill by any method other than those described in this booklet. • Do not use harsh abrasives, caustic cleaners or oven cleaners when cleaning this grill. • Keep the appliance clean and refer to care and cleaning section.
• The appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. • Children shall not play with the appliance. • The appliance should be positioned in a stable situation with the handles positioned to avoid spillage of oil. • Surfaces are liable to get hot during use.
• The installation of a residual current device (safety switch) is recommended to provide additional safety protection when using electrical appliances. It is advisable that a safety switch with a rated residual operating current not exceeding 30mA be installed in the electrical circuit supplying the appliance. See your electrician for professional advice. • Always turn the appliance to the OFF position, switch off at the power outlet and unplug at the power outlet when the appliance is not in use.
• Do not place this appliance on or near a heat source, such as hot plate, oven or heaters. • Position the appliance at a minimum distance of 20cm away from walls, curtains and other heat or steam sensitive materials and provide adequate space above and on all sides for air circulation. IMPORTANT • Fully unwind the power cord before use. Ensure appliance is fully cooled before storing power cord inside the cord wrap.
Components B A E F I G H C D A. Top plate handle B. Top plate C. Flat non-stick cooking plates For extra crispy toasted results. Lower cooking plate has easy wipe corners. D. On/Off switch E. ‘Power’ and ‘Ready’ lights Indicate when the sandwich press is heating or ready to use. 8 F. Adjustable Height Control clip With 3 settings for OPEN MELT, CRUSH CONTROL and LOCK position for vertical storage. G. Non-slip feet H. Convenient cord wrap in base I.
Functions BEFORE FIRST USE Remove any promotional materials and packaging materials before use. Check that the cooking plates are clean and free of dust. If necessary, wipe over with a damp cloth. When using the sandwich press for the first time you may notice a fine smoke haze. This is caused by the heating of some of the components. There is no need for concern. 5. Close the top cooking plate. The top cooking plate has a crush control hinge that is designed to evenly and lightly press down the sandwich.
OPEN SANDWICH MELTS 1. Insert the power plug into a 240V power outlet. Switch the On/Off switch to the ON position. The orange ‘POWER’ light will illuminate. 2. Allow the sandwich press to preheat with the top cooking plate in the closed position until the green ‘READY’ light illuminates. 3. Place sandwich to be melted on the bottom plate. Always place sandwiches in the centre of the bottom cooking plate. 4.
Care & Cleaning Before cleaning, switch the On/Off switch to the Off position and unplug the sandwich press. Allow your sandwich press to cool before cleaning. Always clean your sandwich press after each use to prevent a buildup of baked-on foods. Wipe cooking plates with a soft cloth. If cooked on food is not removed by this method reheat the unit for 1–2 minutes, then brush with a little oil or melted butter. 4. Wrap the power cord in the cord storage area below the appliance.
Breville Customer Service Centre Australian Customers New Zealand Customers Mail: Mail: Locked Bag 2000 Botany NSW 1455 AUSTRALIA Private Bag 94411 Botany Manukau 2163 Auckland NEW ZEALAND Phone: 1300 139 798 Phone: 0800 273 845 Fax: Fax: (02) 9700 1342 0800 288 513 Email: askus@breville.com.au Email: askus@breville.co.nz Web: Web: www.breville.com.au www.breville.co.nz Breville is a registered trademark of Breville Pty. Ltd. A.B.N. 98 000 092 928. Copyright Breville Pty. Ltd. 2016.
