Instruction Manual

22
PROBLEM EASY SOLUTION
The lid cannot be opened
at the end of the cooking
cycle
• Press the STEAM RELEASE button until all internal pressure is released,
and the cooker can be opened.
• If this occurs frequently, the cooker may need to be adjusted to suit your
current altitude. Follow “Altitude Adjust” instructions on page 20.
• NOTE: The safety locking pin will drop when the lid can be opened.
• Using the lid knob, wiggle the lid up and down and then twist open and
close to reduce any friction caused by water or food.
The LID led is flashing and
the buzzer is sounding.
• Turn the lid to the correct position for pressure cooking or slow cooking.
Steam is escaping from
the lid
OR
Safety locking pin does
not rise
OR
Cooker is not getting to
pressure
OR
Timer will not count down.
OR
The screen displays ‘SEAL’
• Assemble the lid correctly ensuring there is no gap between lid arm and
the stainless steel lid. Make sure to secure the lid by screwing on the
sealing nut so that the red seal touches the lid surface; and should be
screwed on tightly.
• Ensure the silicone lid seal is clean, free from damage or cracks and is
properly inserted.
• Ensure that the safety locking pin can move freely up and down.
• When the lid is locked, ensure the safety locking pin is properly aligned
within the opening of the lid arm.
• Ensure that the pressure release valve is properly seated in position and
facing the lid knob.
• Add more liquid/food to the bowl. There should be a minimum of 1 litre
combined food and liquid.
• If problem persists, call Breville Customer Service.
The cooker automatically
switches to keep warm
without going through a
complete cooking cycle
• Add more water to the cooking bowl and restart the cycle.
Water is collecting on the
benchtop
• Ensure the cooker is on a flat level surface and that the condensation
drip cup is installed on the back of the cooker. Follow “Before First Use”
instructions on page 11.
• Empty the condensation drip cup.
The screen displays “Err” • The screen will display “Err” when there is a non-resettable issue with the
appliance. Should this occur, immediately remove the power cord from the
power outlet and contact Breville Consumer Support.
Factory Reset • Press and hold 'soup' and 'sous vide' buttons for three seconds to clear
settings including altitude level.
Troubleshooting